How To Install Aqueon Hinged Glass Top
I accept DIY glass aquariums lids on iii of my planted tanks. They're cheaper to make than almost any lid you can buy commercially and, dissimilar lids with hinges, they permit a ton of lite into the tank.
Each 1 of these lids cost less than $20 and required no tools to make
Pros & Cons to a DIY Glass Aquarium Lid
Higher up y'all tin encounter a glass chapeau on my twenty gallon long planted tank. There are a lot of benefits to a solid drinking glass chapeau like this:
- It wont become cloudy or discolored over fourth dimension like plastic lids
- It wont bend or sag like plastic lids
- Information technology keeps moisture in the aquarium, and blocks almost no light
- It is made custom for your application, then you can cull its dimensions
There are only a couple of reasons NOT to use a solid drinking glass chapeau:
- This design simply works on aquariums with a rim on the top
- They are breakable, and can cause injury to you lot or your fish if cleaved (I accept broken one)
In my stance the benefits definitely outweigh the risks. I have used these lids for years on different aquariums and only ever broken one. No glass actually got into my aquarium, I was moving the hat and not paying enough attention. If you're always careful when handling them, at that place's not much to worry near.
How to Brand a DIY Drinking glass Aquarium Lid
Making one of these lids is very uncomplicated. All y'all need to do is:
1. Measure out your aquarium
Y'all desire the lid to rest on the ledge inside the plastic rim of the tank, so you'll measure from ane inside edge to the other. Then, you have to decide how far across the aquarium you lot want the lid to extend.
In the photo to a higher place you tin can see my HOB filters extend well-nigh two inches into the aquarium. I had my lid cut to leave a picayune more than than 2 inches of open space in the back, so that the filters don't contact or spray water onto the drinking glass. This space on the back side is also handy for dropping nutrient into the tank without moving the lid.
two. Have a piece of glass cut to your dimensions
I have always gone to a local hardware shop to take pieces of glass cut, merely y'all can besides go to a specialty glass shop. I use Ace Hardware in the Denver area, but I have also heard that some Lowes locations will cutting glass. You should be able to find a place that will cut drinking glass in your area.
Since this is just a single pane of glass, it should be less than $20, fifty-fifty for a long cut like my 29" lid beneath. I paid about $10 for that piece of glass that is roughly 29" ten 9".
3. Attach hooks for lifting and moving the chapeau
I utilize clear control mini hooks as handles for these lids. A pack of these hooks is enough for 4-5 DIY aquarium lids, and only adds a couple dollars to the cost of each one.
I like these because they blend in with the glass hat, and they stick on extremely well. Once they are attached, you can lift the chapeau off but using the two hooks as handles.
That's information technology. These lids are like shooting fish in a barrel to make clean using a damp newspaper towel, and the but maintenance they require is being wiped down one time every month or and then. As long equally yous're careful not to drop them, they volition last as long as your aquarium.
If you are interested in other types of DIY aquarium lids, run into my mail service on making lids out of Polycarbonate here.
Source: https://odinaquatics.com/diy-glass-aquarium-lids
Posted by: baileyfordell.blogspot.com
0 Response to "How To Install Aqueon Hinged Glass Top"
Post a Comment